Minimum Program Requirements (MPRs), which set literal and actual boundaries for how LEED certification should be applied, continue to evolve in LEED v4. Here's a short history so farFloor-area ratio is the density of nonresidential land use, exclusive of parking, measured as the total nonresidential building floor area divided by the total buildable land area available for nonresidential structures. For example, on a site with 10,000 square feet (930 square meters) of buildable land area, an FAR of 1.0 would be 10,000 square feet (930 square meters) of building floor area. On the same site, an FAR of 1.5 would be 15,000 square feet (1395 square meters), an FAR of 2.0 would be 20,000 square feet (1860 square meters), and an FAR of 0.5 would be 5,000 square feet (465 square meters).:
The requirements conveyed by the LEED 2009 MPRs have not changed in LEED v4.
However, USGBC has made structural changes to the MPRs in order to maintain alignment with the overall evolution of the rating system. Some MPRs have been relocated to other documents (like a legal form) and some have been incorporated into the rating system as prerequisites. The MPRs that remain more clearly represent the foundational nature of these requirements.
How LEED 2009 MPRs have transitioned to LEED v4.
If you're looking to interpret specific requirements of an MPR, look in the MPR language itself (see the credit language tab) under "Additional Guidance," where applicable, rather than in lengthy supplemental guidance documents.
Questions? Post them in the LEEDuser forum below.
The LEED rating system is designed to evaluate buildings, spaces, and neighborhoods in the context of their surroundings. A significant portion of LEED requirements are dependent on the project’s location, therefore it is important that LEED projects are evaluated as permanent structures. Locating projects on existing land is important to avoid artificial land masses that have the potential to displace and disrupt ecosystems.
All LEED projects must be constructed and operated on a permanent location on existing land. No project that is designed to move at any point in its lifetime may pursue LEED certification. This requirement applies to all land within the LEED project.
There are no comments yet. Start the discussion!
LEED AP BD+C, Executive Editor – LEEDuser
LEEDuser is produced by BuildingGreen, Inc., with YR&G authoring most of the original content. LEEDuser enjoys ongoing collaboration with USGBC. Read more about our team
Copyright 2017 – BuildingGreen, Inc.