Log in
LEED v2009
Neighborhood Development
Smart location & linkages
Smart location

LEED CREDIT

ND-v2009 SLLp1: Smart location Required

LEEDuser’s viewpoint

Explore this LEED credit

Post your questions on this credit in the forum, and click on the credit language tab to review to the LEED requirements.

Credit language

USGBC logo

© Copyright U.S. Green Building Council, Inc. All rights reserved.

Requirements

For all projects
Either (a) locate the project on a site served by existing water and wastewater infrastructure or (b) locate the project within a legally adopted, publicly owned, planned water and wastewater service area, and provide new water and wastewater infrastructure for the project.

AND

Option 1. Infill sites
Locate the project on an infill site.

OR

 

Option 2. Adjacent sites with connectivity

Locate the project on an adjacent site (i.e., a site that is adjacent to previously developed land; see Definitions) where the connectivity of the site and adjacent land is at least 90 intersections/square mile (35 intersections/ square kilometer) as measured within a 1/2-mile (800 meters) distance of a continuous segment of the project boundary, equal to or greater than 25% of the project boundary, that is adjacent to previous development. Existing external and internal intersections may be counted if they were not constructed or funded by the project developer within the past ten years. Locate and/or design the project such that a through-street and/or nonmotorized right-of-way intersects the project boundary at least every 600 feet (180 meters) on average, and at least every 800 feet (245 meters), connecting it with an existing street and/or right of way outside the project; nonmotorized rights-of-way may count for no more than 20% of the total. The exemptions listed in NPD Prerequisite 3, Connected and Open Community, do not apply to this option.

 


Figure 1. Adjacent and connected project site based on minimum 25% of perimeter adjacent to previously developed parcels and at least 90 eligible intersections per square mile (35 intersections/square kilometer) within 1/2 mile (800 meters) of boundary segment adjacent to previous development

 

Figure 2. Project site with through-street right-of-way intersecting project boundary at least every 600 feet (180 meters) on average

OR

Option 3. Transit corridor or route with adequate transit service
Locate the project on a site with existing and/or planned transit service such that at least 50% of dwelling units and nonresidential building entrances (inclusive of existing buildings) are within a 1/4 mile (400 meters) walk distance of bus and/or streetcar stops, or within a 1/2 mile (800 meters) walk distance of bus rapid transit stops, light or heavy rail stations, and/or ferry terminals, and the transit service at those stops in aggregate meets the minimums listed in Table 1 (both weekday and weekend trip minimums must be met). Projects must meet the requirements for both weekday and weekend trips and provide service every day. Commuter rail must serve more than one metropolitan statistical area (MSA) and/or the area surrounding the core of an MSA (or a local equivalent for projects outside the U.S.) . Table 1. Minimum daily transit service

Weekday trips

Weekend trips

Projects with multiple transit types (bus, streetcar, rail, or ferry)

60

40

Projects with commuter rail or ferry service only

24

6

See all forum discussions about this credit »

What does it cost?

Cost estimates for this credit

On each BD+C v4 credit, LEEDuser offers the wisdom of a team of architects, engineers, cost estimators, and LEED experts with hundreds of LEED projects between then. They analyzed the sustainable design strategies associated with each LEED credit, but also to assign actual costs to those strategies.

Our tab contains overall cost guidance, notes on what “soft costs” to expect, and a strategy-by-strategy breakdown of what to consider and what it might cost, in percentage premiums, actual costs, or both.

This information is also available in a full PDF download in The Cost of LEED v4 report.

Learn more about The Cost of LEED v4 »

Addenda

2/2/2011Updated: 2/14/2015
Reference Guide Correction
Description of change:
In the last sentence of the first paragraph, replace "service" with "use"
Campus Applicable
No
Internationally Applicable:
No
10/1/2013Updated: 2/14/2015
Reference Guide Correction
Description of change:
Revise connectivity definition to:
“connectivity the number of publicly accessible intersections per square mile, including any combination of streets, dedicated alleys, transit rights-of-way, and nonmotorized rights-of-way. If one must both enter and exit an area through the same intersection, such an intersection and any intersections beyond that point are not counted; intersections leading only to culs-de-sac are also not counted. The calculation of square mileage excludes water bodies, parks larger than 1/2 acre, public facility campuses, airports, rail yards, slopes over 15%, and areas nonbuildable under codified law or the rating system. Street rights-of-way may not be excluded.”
Campus Applicable
No
Internationally Applicable:
Yes
7/1/2014Updated: 2/14/2015
Global ACP
Description of change:
In the first paragraph behind 'state fish and wildlife agencies' add “(or a local equivalent for projects outside the United States)”

Add the flowing statement at the end of the first sentence: “(local equivalent standards for threatened and endangered species may be used by projects outside the U.S. if the site area is not covered by NatureServe data).”
Campus Applicable
No
Internationally Applicable:
Yes
10/1/2013Updated: 2/14/2015
Rating System Correction
Description of change:
Revise connectivity definition to:
“connectivity the number of publicly accessible intersections per square mile, including any combination of streets, dedicated alleys, transit rights-of-way, and nonmotorized rights-of-way. If one must both enter and exit an area through the same intersection, such an intersection and any intersections beyond that point are not counted; intersections leading only to culs-de-sac are also not counted. The calculation of square mileage excludes water bodies, parks larger than 1/2 acre, public facility campuses, airports, rail yards, slopes over 15%, and areas nonbuildable under codified law or the rating system. Street rights-of-way may not be excluded.”
Campus Applicable
No
Internationally Applicable:
Yes
7/19/2010Updated: 2/14/2015
Reference Guide Correction
Description of change:
At the end of the term description of "dwelling unit," insert a period
Campus Applicable
No
Internationally Applicable:
No
7/19/2010Updated: 2/14/2015
Reference Guide Correction
Description of change:
In the image in the top left corner, change the reference from "b" to "a"
Campus Applicable
No
Internationally Applicable:
No
10/1/2012Updated: 2/14/2015
Reference Guide Correction
Description of change:
Revise connecitivity definition to the following: connectivity the number of publicly accessible intersections per square mile, including any combination of streets, dedicated alleys, transit rights-of-way, and nonmotorized rights-of-way. If one must both enter and exit an area through the same intersection, such an intersection and any intersections beyond that point are not counted; intersections leading only to culs-de-sac are also not counted. The calculation of square mileage excludes water bodies, parks larger than 1/2 acre, public facility campuses, airports, rail yards, slopes over 15%, and areas nonbuildable under codified law or the rating system. Street rights-of-way may not be excluded.
Campus Applicable
No
Internationally Applicable:
No
2/2/2011Updated: 2/14/2015
Rating System Correction
Description of change:
In the last sentence of the first paragraph, replace "service" with "use"
Campus Applicable
No
Internationally Applicable:
No
7/1/2014Updated: 2/14/2015
Global ACP
Description of change:
Replace the first sentence of the second paragraph with the following: "Projects must meet the requirements for both weekday and weekend trips and provide service every day. Commuter rail must serve more than one metropolitan statistical area (MSA) and/or the area surrounding the core of an MSA (or a local equivalent for projects outside the U.S.)"

Replace all instances of "square footage" with "floor area"
Section a.
Behind "the Federal Transit Administration " add: "(or equivalent national agency for projects outside the U.S.)”

Section c.
In the first paragraph under the "OR" section, replace “municipality” with “local government.”
Campus Applicable
No
Internationally Applicable:
Yes
2/2/2011Updated: 2/14/2015
Reference Guide Correction
Description of change:
In the third line, remove the text "(up to 20% of total intersections)"
Campus Applicable
No
Internationally Applicable:
No
See all forum discussions about this credit »

Documentation toolkit

The motherlode of cheat sheets

LEEDuser’s Documentation Toolkit is loaded with calculators to help assess credit compliance, tracking spreadsheets for materials, sample templates to help guide your narratives and LEED Online submissions, and examples of actual submissions from certified LEED projects for you to check your work against. To get your plaque, start with the right toolkit.

USGBC logo

© Copyright U.S. Green Building Council, Inc. All rights reserved.

Requirements

For all projects
Either (a) locate the project on a site served by existing water and wastewater infrastructure or (b) locate the project within a legally adopted, publicly owned, planned water and wastewater service area, and provide new water and wastewater infrastructure for the project.

AND

Option 1. Infill sites
Locate the project on an infill site.

OR

 

Option 2. Adjacent sites with connectivity

Locate the project on an adjacent site (i.e., a site that is adjacent to previously developed land; see Definitions) where the connectivity of the site and adjacent land is at least 90 intersections/square mile (35 intersections/ square kilometer) as measured within a 1/2-mile (800 meters) distance of a continuous segment of the project boundary, equal to or greater than 25% of the project boundary, that is adjacent to previous development. Existing external and internal intersections may be counted if they were not constructed or funded by the project developer within the past ten years. Locate and/or design the project such that a through-street and/or nonmotorized right-of-way intersects the project boundary at least every 600 feet (180 meters) on average, and at least every 800 feet (245 meters), connecting it with an existing street and/or right of way outside the project; nonmotorized rights-of-way may count for no more than 20% of the total. The exemptions listed in NPD Prerequisite 3, Connected and Open Community, do not apply to this option.

 


Figure 1. Adjacent and connected project site based on minimum 25% of perimeter adjacent to previously developed parcels and at least 90 eligible intersections per square mile (35 intersections/square kilometer) within 1/2 mile (800 meters) of boundary segment adjacent to previous development

 

Figure 2. Project site with through-street right-of-way intersecting project boundary at least every 600 feet (180 meters) on average

OR

Option 3. Transit corridor or route with adequate transit service
Locate the project on a site with existing and/or planned transit service such that at least 50% of dwelling units and nonresidential building entrances (inclusive of existing buildings) are within a 1/4 mile (400 meters) walk distance of bus and/or streetcar stops, or within a 1/2 mile (800 meters) walk distance of bus rapid transit stops, light or heavy rail stations, and/or ferry terminals, and the transit service at those stops in aggregate meets the minimums listed in Table 1 (both weekday and weekend trip minimums must be met). Projects must meet the requirements for both weekday and weekend trips and provide service every day. Commuter rail must serve more than one metropolitan statistical area (MSA) and/or the area surrounding the core of an MSA (or a local equivalent for projects outside the U.S.) . Table 1. Minimum daily transit service

Weekday trips

Weekend trips

Projects with multiple transit types (bus, streetcar, rail, or ferry)

60

40

Projects with commuter rail or ferry service only

24

6

See all LEEDuser forum discussions about this credit » Unsubscribe from discussions about ND-v2009 SLLp1